Minimum system requirements
Intel® Pentium® 120 with MIDI sound card or external MIDI port running Windows 95, 98, or NT 4.0 or greater.
Instructions
1. Download the zip file to your computer.
2. Open the file using WinZip® or another Windows unzip utility and select "Install," OR extract the files to a temporary directory and run setup.exe.
3. View the ReadMe file located in the Updater directory for information on this software update.
4. Run Updater from the Start menu.Warnings
• Close all programs before running Updater.
• Updater is not compatible with sound cards and MIDI ports that continually transmit Active Sensing messages. Most do not, however this feature must be disabled on devices that do before attempting an update.
The JM-250H uses FLASH memory to store the Operating System Software, allowing you to update your Millennium at your convenience. The links above contain the applications necessary for updating a JM250H using a PC (Mac versions are in progress) as long as you have a MIDI interface connected to your computer.
NOTE: The DOS updater has been tested succesfully when using MPU-401 DOS compatible MIDI cards...although many cards with MIDI are listed as MPU-401 compatible, they may not be DOS compatible.
JM250 Version 1.05
1. Fixed Whammy Pedal parameter range from 0 -100 to 0 - 127.
2. Includes all previous software version release changes.
JM250 Version 1.04
1. Removed default parameter settings in version 1.02 for the PEQ6 and the STPEQ6 that were called Fendor 1, Fendor 2, & Fendor 3. This caused problem when dumping presets from older version that needed these settings. These settings were restored but called Curve 1, Curve 2, & Curve 3.
2. Previously the foot pedal position was ignored when changing to a new preset until the pedal was moved. There is now a Utility Menu option to update the Volume Pedal (when linked) with the current pedal position when the preset is changed. The new utility page selects Pedal Update mode. Default is Off, but when switched to On, the Volume Parameter will update automatically reflecting the pedal position when preset is changed.
3. Added seven new Effects: Half Reverse Delay, Full Reverse Delay, Time Warp, Smooth Detune, Half Sampler, Full Sampler, Stereo Sampler.
4. Changed Factory Preset #5 to use the Reverse Delay.
5. Fixed problem when scrolling through effect module #2 of Configuration #10.
6. Slowed down Bulk Dump rate so that Cakewalk and Windows 95 can keep up.
7. Includes all previous software version release changes.
Specifications Subject to Change without Notice
JOHNSON AMPLIFICATION
8760 South Sandy Parkway, Sandy, UT 84070 USA
Phone: (801)566-8919 Fax: (801)566-7005 Int'l Fax: (603)672-4246
Copyright ©1998 Johnson Amplification, a Harman International Company